THE BARGAIN ZONE

    Tel: 516-536-7375         Fax: 516-536-7317         

E-mail:    rigs@sunmachinery.us          Contact US

 

 

INGERSOLL RAND ROCK DRILL PACKAGE  (REF#6107R)

 

          A.   2006 ATLAS COPCO ECM-585MC ROCK DRILL

 

              

 

    Cummins 5.9L- engine rated power 142KW, enclosed cab, AC, steel tracks, dust collector, 7,003 H. showing 1,211 drifter hours

 

          B.   2002 INGERSOLL RAND ECM-580 ROCK DRILL

   

             

 

    Cummins 5.9L – 127KW engine rated power (Recon Eng Installed 12/21/2006) steel tracks, enclosed cab, AC, dust collector, drifter hours 1,088; engine hours 8,451

 

    PRICE:  $225,000 or BEST OFFER 

 

GARDNER DENVER 5 x 6 MUD PUMP  (REF#6091R)

 

       

 

Air operated, just tested and runs well.  Video available on request

PRICE:  $13,500

 

SCHRAMM T660  (Ref#6053R) 

Manufactured 2002, 1000/350 Sullair compressor, Cummins N14 deck engine, 25 gpm water injection, hammer oiler, mounted on 2002 International truck  Price:  $185,000

(Ref#11148R)  4000’ 4-1/2” x 25’ drill pipe with 2-7/8 IF, flush joint, good condition  Price:  $375 per joint

     

ROBBINS RTT-50 (Ref#7165R)

Manufactured 1981, fully  refurbished, PTO, mounted on 4 axle carrier with Cummins 350 engine, 800/125 air compressor (updated to 1000/125), 4 rod carousel, dust collector, 33000# pullback, 50000# pulldown, 200,000 ft/lbs torque, 38’ mast, rear cab, 16” opening in table, hydraulically raised and lowered drilling platform, used for large diameter blasthole, (3) joints of 5” x 25’ drill pipe   Price $150,000

PRICE REDUCED:  $80,000

REICHDRILL 690 (Ref#6877RA) Manufactured 1997, 50000# pullback, Cat 3406 deck engine, mounted on 1996 International Paystar with N14 Cummins, GHH CF1000 air compressor, 6 rod carousel, pipe rack, electric line oiler, water injection, 3 hydraulic leveling jacks, QL60 hammer, QL80 hammer with stabilizer, 420’ of 4 ½” x 20’ drill pipe ( 3 1/2” reg api conn)  Price:  $165,000

 BUCK ROGERS 760  (Ref#15707R) 

MWM diesel on deck 2700 rpm, 3 x 4 Mission mud pump, mounted on 1992 Ford F800 4 x 4 truck with 7.8L diesel engine, (2) 50 gal fuel tanks, 37,575 miles on truck 

Price:  $40,000  Price Reduced:  $29,500

DEEPROCK DR20  (Ref#85R) 

 

mounted on 2001 Ford F250 truck with diesel engine, manual transmission, (2) Kohler engines on deck, centrifugal mud pump 1-1/2 x 2 with 9” impeller

200’ of 5’ stems, misc. equipment included,  Ready to Drill

Price:  $35,000  Price Reduced:  $24,500

CHICAGO PNEUMATIC 650  (Ref#13865) 

       

Manufactured 1971, 450/250 air compressor, mounted on Ford truck with gas engine, Cat engine on deck, rods and standard tools, 12 gpm water pump  Price:  $60,000  PRICE REDUCED:  $40,000

JASWELL 2400  (Ref#114R) 

       

Manufactured 1990, 1000/350 Sullair compressor, Detroit 12V92 diesel engine, Bean pump, mounted on International Paystar 5000 with Cummins Big Cam 400, 8” hammer, bit, stabilizer  Price:  $72,000

(Ref#10644N)  12,000’ of Ingersoll Rand RD20 Range II    4-1/2” x 30’ drill pipe, 2-7/8” IF conn  Price:  $295 per joint  PRICE REDUCED:  $245 per joint

 

INGERSOLL RAND T4BH  (Ref#6123Ra) 

         

Manufactured 1980, low pressure, Detroit diesel deck engine, mounted on CCC (has 400 Cummins engine for truck that needs to be installed), 1200’ pipe.  PRICE: $38,000

INGERSOLL RAND 900/350 AIR COMPRESOR (209R)

     

       

 

Manufactured 1990

1070 CFM/350 PSI

CAT 3406B diesel engine

475 BHP

230 gallon fuel tank

In Wisperized wagon with no wheels

Mounted on steel oilfield skid

Dimensions & Weight

18’5” long x 7.5” wide x 8’4” High

Wt. 16000#

Good operating condition

As removed from service.

Located Baltimore, MD

PRICE:  $38,000  REAL BARGAIN 

INGERSOLL RAND T4  (Ref#1623N) 

     

Manufactured 1976, 50,000# pullback, 600/250 air compressor, 8V71 Detroit diesel on deck, mounted on Crane Carrier with 6V53 Detroit engine, 5 rod carousel, rod racks, fully tooled, 500’ drill pipe, good running condition  Price:  $115,000  PRICE REDUCED:  $85,000

 

CHICAGO PNEUMATIC 650WS  (Ref#4987N) 

       

Manufactured 1984, 800/300 Sullair compressor, new Cat 3406 deck engine (40 hours), mounted on International Paystar truck, 13 speed, 18 gpm water injection, pipe loader, 10” table, winch, no pipe  Price:  $105,000  PRICE REDUCED:  $70,000

 

VERSADRILL V100 (Ref#5008N)

   

Manufactured 1990, low hours,  PTO, mounted on 1987 GMC Brigadier with diesel engine, 300/200 air compressor, Gardner Denver 5x6 mud pump, also 3x4 centrifugal mud pump, 24’ stroke, 1 winch, jib boom, portable mud pit, no carousel, rod box, set up for 3 ½” rods   Price:  $150,000 REDUCED:  $120,000 

Pipe available at extra cost

 

SCHRAMM T450W  (Ref#6751N) 

 

     

 

Manufactured 1995, 825/350 GHH air compressor (rebuilt 2005, new clutch, only 325 hours since overhaul, rig used mainly for mud drilling), Detroit 8V71TA (388 hp) deck engine (9,300 hours, rebuilt at 7,680 hours), mounted on Ford LTS 8000 6 x 4 truck with Cummins 8.3L (250 hp), new in 2010 3 x 4 centrifugal Mission pump, 10,000# winch, sandline winch, carousel, rod box, hammer oiler, 9 gal Bean water injection pump, tool box, 30,000# pullback, 16” table opening, 25’ head travel, rotation torque limiter, 2 speed top head (0-136 rpm, 106,608 in/lbs), 3 outriggers, 6 pipe side box, 60” pipe wrench, sliding top head, junk box, hammer holders, approx 300’ of drill pipe  Price:  $220,000 PRICE REDUCED:  $180,000

 

1992 GMC WATER TRUCK (Ref#11761R)  1000 gallon water tank, 24’ bed, Quick Load grouter (model QLB15011P, year 2002), mounted on 1992 GMC Topkick, 167,000 miles, rack for carrying mud mats, straps on side for casing, truck runs great with no leaks Price:  $29,500 PRICE REDUCED:  $18,500

 

 

DRILTECH T25K3W  (Ref#9039Na) 

 

   

 

Manufactured 1994, 840/350 air compressor, 5 x 6 Gardner Denver mud pump, CAT 3406, mounted on 1994 Ford L8000 truck, 31,000 miles with 8.3 Cummins engine, 420’ of 4-1/2” x 20’ drill rods

Price rig only:  $220,000

1981 INTERNATIONAL WATER TRUCK  (Ref9039Nb)  270 Cummins engine, 2200 gallon water capacity mud pan 

Package Price:  $245,000

PACKAGE PRICE REDUCED TO $175,000

 

 

1993 REICHDRILL T650W  (REF#2528R)

 

     

 

825/350 GHH air compressor, CAT 400HP deck engine, 1993 Ford L 8000 carrier, brand new suspension, standard mast, 50,000# pullback, 6 rod carousel, new air filter and oil in compressor, 20’ drill collar, 7- 7/8” bit, 6” bits, hammer, 300’ of drill pipe, needs a new oiler box.

PRICE:  $140,000

TRIPLE H ROCK DRILL  (Ref#9291R) 

     

Manufactured by Smith Mining Equipment in 1996, Deutz diesel deck engine, mounted on 1996 GMC Top Kick (only 41,500 miles) with Cat diesel engine, 5 speed, complete with 16’ Numa 120 hammer with extension and cassion guide and brand new 17-1/2” bit, can drill up to 16’ depth  Price:  $45,000 PRICE REDUCED:  $38,000

INGERSOLL RAND TH60 (Ref#7229N)

 

Manufactured 1979, mounted on ’79 International Paystar with Detroit engine, 750/250 air compressor, rebuilt 5 x 6 Gardner Denver mud pump, new swivel & slider box, 1 main winch, 7 rod carousel, rod box, 1000’ of 4 ½” x 20’ drill pipe,  6” hammer with bit

Price:  $140,000  PRICE REDUCED:  $85,000 - Loc. California

DRILTECH D25  (Ref#7892Na) 

     

Manufactured 1987, 840/350 air compressor, Cat 3206 deck engine (needs work), mounted on 1987 Ford truck with Ford diesel engine, 6 rod carousel, water injection, hammer oiler, 360’ of 4-1/2” x 20’ drill pipe, 6” hammer, tools, 4 hyd leveling jacks,  Price:  $120,000

1978 FORD WATER TRUCK  (Ref#7892Nb)  1500 gallon Amthor flat tank, 240 gallon aux fuel, crane  Price:  $25,000

PACKAGE PRICE:  $110,000

SPEEDSTAR SD300  (Ref#6755) 

     

Manufactured 1993, 11,000 hours, mounted on Ford L9000 tandem axle truck with 3406 Cat (350 hp) diesel engine, 8 speed transmission, 4 hydraulic leveling jacks, 3x4 Mission Magnum pump, LeRoi TS17G2 600/300 compressor, 60000# mast, 15000# pulldown, 20000# hoist, 10000# winch with traveling block, jib boom, front mounted 20000# winch, pipe spinner, breakout wrench, toolboxes, pipe rack, single rod loader, Meyer water injection pump, hammer oiler, handling tools, 

Price:  $105,000  PRICE REDUCED:  $85,000

 

    Tel: 516-536-7375         Fax: 516-536-7317         

E-mail:    rigs@sunmachinery.us          Contact US